- Tue Jan 05, 2021 12:58 pm
#47445
I need to run some additional outputs (VVT, Boost) and inputs (oil pressure) from existing connector pins to the appropriate place on the board.
What's the recommended method to connect existing unused connector pins to the board?
It looks like unused pins do not have tracks on the PCB
That leaves soldering directly to the pin(s)?
Soldering on the bottom of the board might foul the Ardiuno (esp. USB connector)?
What's the recommended method to connect existing unused connector pins to the board?
It looks like unused pins do not have tracks on the PCB
That leaves soldering directly to the pin(s)?
Soldering on the bottom of the board might foul the Ardiuno (esp. USB connector)?