Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For anything related to the 'official' Speeduino boards (Eg v0.3, v0.4 etc)
By tx_haggis
#45841
Background: installing a BP4W (VVT) into a 1990 NA Miata

I've wired ECU pin 2I direct to the tach (by joining the yellow/blue and black/white wires at the ignitor). Do I:
  • Do nothing? :D
  • Set the tach output in software?
  • Install a jumper on the tach pins on the board?
Or some combination of the above?
By mater36
#45954
I did this on a 92 miata with a vvt engine as well. Tach output is just like you said. I connected the two pins at the igniter and used the jumper. The default settings for the tach output on tuner studio worked just fine.

Coffee break: The Tuner Studio gauge shows Speedui[…]

Minimalistic ECU (RC engines)

Another pic with components. There is nothing on[…]

does not start

Here's the startup log, but it never started. I ha[…]

Thanks for answers, have a good day. I have seen […]

Still can't find what you're looking for?