Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For anything related to the 'official' Speeduino boards (Eg v0.3, v0.4 etc)
By tx_haggis
#45841
Background: installing a BP4W (VVT) into a 1990 NA Miata

I've wired ECU pin 2I direct to the tach (by joining the yellow/blue and black/white wires at the ignitor). Do I:
  • Do nothing? :D
  • Set the tach output in software?
  • Install a jumper on the tach pins on the board?
Or some combination of the above?
By mater36
#45954
I did this on a 92 miata with a vvt engine as well. Tach output is just like you said. I connected the two pins at the igniter and used the jumper. The default settings for the tach output on tuner studio worked just fine.
Problem with fuel pump outlet

Hello again. I think I found the problem, it is t[…]

Here are wiring diagrams for three Ch(203 or 209) […]

Ok, you can't bypass the 5v regulator, it must hav[…]

Modified 3 cylinder

You should read up on how OEM go about shutting do[…]

Still can't find what you're looking for?