[RempageR1]

Hi,

I`ve moved TS to another computer and now i do not have the values for the coolant sensor anymore. Is there a way to get the current values out of the Teensy`s EEPROM? They are stored there so I`m hoping to get them out.

Thank you.

[jonbill]

I don't think there is an existing method to extract them.
Speeduino does read them, so I guess you could hack a speeduino build that outputs them (to TS/log)
But... It doesn't have your original 3 value pairs stored - it stores 32 pair that TS calculated from your 3. But I think you should be able to just pick 3

[RempageR1]

There is a command if you connect via serial to dump the calibration data. So got it now, thanks!

[jonbill]

Oh, what's that command? Would be good to know.

[RempageR1]

A bit late but it`s Z.

See this link for more info:
https://wiki.speeduino.com/en/reference ... e_Protocol

[ChaimReilly]

Hi,fall guys

I`ve moved TS to another computer and now i do not have the values for the coolant sensor anymore. Is there a way to get the current values out of the Teensy`s EEPROM? They are stored there so I`m hoping to get them out.

Thank you.

In my opinion, extracting it depends on It doesn't have your original 3 value pairs stored - it stores 32 pair that TS calculated from your 3.

[RempageR1]

Indeed. So then I reverse-engineered the 3 original values by modifying them untill they (almost) matched the 32-values stored in the calibration data. That was close enough, 1 or 2 degrees off doesn't really matter.