Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Any general discussion around the firmware, what is does, how it does it etc.
By Dave3891
#45692
Hi, I am going to be starting a boosted vortec 4200 build that had a GM 7X wheel on it.
I would like to run sequential on it as I am going to add a individual EGT sensor per runner to trim each cylinder.
Looking online a bit it looks like the 4200 has been attempted before, but the trigger setting were not working correctly?

Also looking at the code, there is nothing for the secondary trigger input, which I would need to get a 720 degree trigger.

Should I continue down the path of using the stock trigger setup or would it make more sense to just switch to a different custom wheel?
By Dave3891
#45697
The vortec 4200 does have a cam wheel (see attached pattern) so that should be able to make it work?
75099392-d5160900-55c9-11ea-9bdb-fe08020ec407.png
75099392-d5160900-55c9-11ea-9bdb-fe08020ec407.png (32.76 KiB) Viewed 575 times
11735015_dor_918185_pri_larg.jpg
11735015_dor_918185_pri_larg.jpg (29.03 KiB) Viewed 575 times
By pazi88
#45708
There is no secondary (cam) trigger implemented for GM7X in Speeduino. Only crank trigger. So grinding off tooth from that doesn't help. I didn't even know that GM7X has cam trigger wheel because only knowledge I can have found about it, includes only the crank trigger wheel.
By Dave3891
#45715
If I switch to a 36-1 crank wheel and single tooth cam wheel, does it matter where the cam tooth is located in the cycle? Does it have to be at TDC #1?

Is there a reason why you want to log this info? […]

MX-5 (Miata) NB8A Mk2 99-00

It’s a 0.4.3c Speeduino wiki says pin 1 is […]

Back feeding usb

Just curious has anybody had any problems powering[…]

Guess I got more done than I expected I would toda[…]

Still can't find what you're looking for?