I've had exactly the same issue here -My hardware is an Elegoo Mega2560R3 with the MEGA16U2 serial chip. I've tried it both on and off the Speeduino (0.4.3c) board.SpartanSv wrote: ↑Sat Jun 20, 2020 1:16 amI think I'm having exactly the same issue. Rolled back to the old firmware for now.Fatman wrote: ↑Wed May 27, 2020 1:10 pmHello, I am absolutely loving Speeduino so far! I have been using a speeduino 0.4.3c in my Clio 1.2 turbo for 6 months or so. Had to make my own fly by wire controller which is a bit crude but works well enough for me.
I have an issue with the new firmware, in that tuner studio does not want to connect to it at all.
I usually download the arduino code and upload it and then add the .ini file to the tuner studio project.
This time it came back that the firmware version on the arduino was SP (whatever that means) but I added the .ini file anyway
It then failed the communications test and point blank refused to connect once the project was opened.
I tried this again with the same results and also re downloaded the firmware just in case. Also re installed tuner studio
I then decided to try using speedyloader, used the .ini file it downloaded. The results are largely the same except I noticed tuner studio looked like
it was trying to connect and failing (the progress bar came up and froze). I also noticed the
injectors buzzing away. I suspect that for whatever reason serial comms were being made and broken rapidly and the arduino was resetting continuously. After this I tried many things including creating a project from scratch, restarting the computer a few times also there were no further attempts made by tuner studio to connect.
After this I gave up and re uploaded 202002 which works flawlessly.
I have talked to my friend who says he has updated 2 cars with no issues..
So really I am at a bit of a loss with how to attack this next.
I should also say, this us using USB not bluetooth.
Any advice would be greatly appreciated!
Anyone have any thoughts?
This is really interesting - but I'm curious what these two different lines actually do?turtana wrote: ↑Fri Jul 31, 2020 7:20 ami had some troubles with 05 code too, well not found out what is the cause.
it cut´s out serial and will not connect "invalid data received"
if you try and unplug the usb it will shut down engine until you power of completely.
so from the ini at row ~3779 i changed, ochGetCommand = "r\$tsCanId\x30%2o%2c"
to ochGetCommand = "A"
and now it won´t get stuck and read fps got up from 6 to 20fps with BT connection. i don´need can options so no problem on that.
A few things that may help it respond better and a[…]
… The vacuum point is actually almost ex[…]
Whatever the schematic shows will be correct.
I see the same thing on a 60-2 + 1 tooth on cam, i[…]