[OldKamikaze]

Hello,

Working on J35A4.

Would like to have/contribute/test to trigger patterns to J35/J30/J32 (they are looking very similar)
Patterns:
Crank: 12+12+0 (No missing)
Cam: 6+4+2 (2missing)

Funny thing J35a4 have 2 Cam sensors (180 degrees apart). Any advices on this one?

Is any dev on this one or code? What engine resembles this one? I'll take is a template.

Thnx to all in advance

[PSIG]

ZCrank: 12+12+0 (No missing)
Cam: 6+4+2 (2missing)

I don't have that set of patterns on file. Your description does not appear to follow naming convention for + or - teeth, and does not translate to a valid pattern. Please provide a drawing, or image, or oscilloscope pattern, etc.

[OldKamikaze]

ZCrank: 12+12+0 (No missing)
Cam: 6+4+2 (2missing)

I don't have that set of patterns on file. Your description does not appear to follow naming convention for + or - teeth, and does not translate to a valid pattern. Please provide a drawing, or image, or oscilloscope pattern, etc.

Will do, have oscilloscope

[LPG2CV]

Do you mean something simular to this, when you say 12+12+0?

[OldKamikaze]

Do you mean something simular to this, when you say 12+12+0?

I guess I do not understand labeling on trigger patterns.

It is just a disc with evenly spaced 12 tooth .

[OldKamikaze]

Unfortunately my ECU declined to steam pulses, but this is what oscilloscope gave me.

See attached office file, making the cam gear

[OldKamikaze]

There is no point using second cam sensor, as is at the cam picture i edited in this position we get cyl1 TDC. So sensor 1 is the best and easy to detect as is first to pick after missing tooth is 1 cyl TDC

[OldKamikaze]

Some filtering in human/binary form.

Every fifth tooth is a cylinder TDC. After missing teeth on cam, first tooth is 1 cyl TDC

[OldKamikaze]

any hints what resembles best to this? It should work with j35/j32/j30?

Thnx in advance

[OldKamikaze]

Important correction. I believe the line on a cam indicates the TDC, so it should look like this. TDC on a fall, not rise