- Mon Jan 11, 2016 9:23 pm
#5039
Can launch control be implemented with the use of speed input ?
i was thinking like multiple rev limit maps with an analog multistage switch .
for example if :
switch is on 0 possition - analog input 0v - no launch control ( normal rev limit )
switch is on 1 position - analog input 1v - launch control (rev limit) set at x value ( like 4200rpm)
switch is on 2 position - analog input 2v - launch control (rev limit) set at y value ( like 5000rpm)
all depending on VSS ( vehicle speed signal )
if input from vss missing use rev limit map 0,1,2 ( wich one is selected from switch )
if input from vss is greater than 5 km/h ( mph) whitch to base rev limit map
Thank you!
kind regards
Alex M
i was thinking like multiple rev limit maps with an analog multistage switch .
for example if :
switch is on 0 possition - analog input 0v - no launch control ( normal rev limit )
switch is on 1 position - analog input 1v - launch control (rev limit) set at x value ( like 4200rpm)
switch is on 2 position - analog input 2v - launch control (rev limit) set at y value ( like 5000rpm)
all depending on VSS ( vehicle speed signal )
if input from vss missing use rev limit map 0,1,2 ( wich one is selected from switch )
if input from vss is greater than 5 km/h ( mph) whitch to base rev limit map
Thank you!
kind regards
Alex M