Firmware live stream happening this weekend: viewtopic.php?f=13&p=43195
For anything you'd like to see added to Speeduino
User avatar
By PSIG
#40237
I recall this specific pattern was discussed previously. Might find it in searching, but the bottom-line is that no special decoder is required, and polarity, edges and settings are important. You are only reading one edge (leading or trailing tooth face), so pick the appropriate one and verify everything is set to read that edge.

David
PCB for BMW m52 engine

Hi! Leave out the IGBTs and jump over those like t[…]

NA VVT Swap No Start

Relevant manual page: https://wiki.speeduino.com[…]

E190 2.3 8V FUEL ONLY

I think there is a reason why OEM bosch costs 70$ […]

May 2020 firmware release

I could try the 680 ohm, but the onboard pullup […]

Still can't find what you're looking for?