Page 2 of 2

Re: rover MEMs decoder

PostPosted:Sat Mar 17, 2018 10:32 am
by andymcg
Has there been any progression on this? I am looking to use speeduino for my k series. is it possible to run using standard sensor and flywheel rather than fitting a 36-1 wheel? I have the 0.4.3 board with vr conditioner

Re: rover MEMs decoder

PostPosted:Sat Mar 17, 2018 10:42 am
by dazq
Not heard anything :-( perhaps you could put in another request on git for the feature!

Re: rover MEMs decoder

PostPosted:Mon Oct 05, 2020 8:52 pm
by Cedric dumas
Do you have any solution for mems 1.9 trigger

Re: rover MEMs decoder

PostPosted:Wed Oct 07, 2020 12:47 pm
by Dziku
Any progres? Is it posible to run vvc with vvt output? Theoreticaly it should work if we add cam trigger, and know the specs of the valve...

Re: rover MEMs decoder

PostPosted:Thu Oct 08, 2020 10:28 pm
by miker
I'm going to have a watch of the video on making trigger patters again. If it makes sense I may have a play.

Re: rover MEMs decoder

PostPosted:Fri Oct 09, 2020 9:06 am
by dazq
Have a search on the Facebook group.
Someone did write a working mems decoder a while back but never submitted a pr for it via GitHub.
It may save some time rather than starting from scratch.