Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
User avatar
By panjaycee
#68376
Hello I have a ua4c board and I just finished tuning my car and it runs great, no sync loss or missing. I went ahead and saved the tune on tuner studio and unplugged the laptop. I restarted the car and it runs for maybe 10 seconds and it stalls out on its own. I plug the laptop back in and it stays running just fine.
I checked for 12v at the fuse to the ecu and it was fine. Not sure where to go from here. Any help is appreciated, thanks for looking.
#68381
I have taken the board out of the case and nothing smells or looks burnt. I connected to the pc to see if anything acts up, so far only the microcontroller part of the arduino starts to get warmer after a minute or two.
Fuel Pump for a 150cc

I can recommend the Suzuki 15100-03H11(or rather t[…]

Anyone with ESP32C3?

Look how cute that little fella is. Now I just nee[…]

Honda's Alternator Control is just a PWM based o[…]

For Peugeot Valeo throttle valve to fix throttle[…]

Still can't find what you're looking for?