- Sun May 01, 2022 3:09 am
#56752
Im having trouble with the idle up function, When first enabled before reboot the selected pin works fine (in my case im using Arduino pin D40) after reboot any change on the pin isn't seen by the firmware. Disable idle up, reboot and reselect it makes it work again until next reboot. My pin 40 isn't defined in the pin mapping so i'm not overriding a pre programmed pin.
If i use the input pin for anything else it works fine.
Has anyone else having this problem 202108 firmware?
and no i can't run the current release as im using the STM32F407 and the comms is still too buggy to risk an engine on.
If i use the input pin for anything else it works fine.
Has anyone else having this problem 202108 firmware?
and no i can't run the current release as im using the STM32F407 and the comms is still too buggy to risk an engine on.