Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
#54768
As shown in the following pictures, on the latest firmware releases, if we attempt to change large ares of the maps with < > cursors on the keyboard, a protocol error appears, and a reset of the bard is required in order to reinitiate the com.
This was not happening with the previous firmwares, attempt was done on 3 different genuine arduino mega boards, and 2 different usb cables.
Tests were done after a fresh install with speedyloader of the latest 202202 firmware, with relative ini file, and base tune
Attachments
Comunication error Speeduino v1.png
Comunication error Speeduino v1.png (416.93 KiB) Viewed 3784 times
Comunication error Speeduino v2.png
Comunication error Speeduino v2.png (466.27 KiB) Viewed 3784 times

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?