Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
User avatar
By Bear27
#52229
Hello,I have a m50 pnp from rm racing electronics with the mod for vag cops. The problem is that I have no spark signal,crank signal and everything else seems ok.Can this be firmware related?
By theonewithin
#52231
So you have no crank signal?

Could you provide a copy of your tune and log when cranking?

Without either we cannot help
User avatar
By Bear27
#52234
Yes i have the selected the right board..crank signal looks good and it shows about 200rpm when cranking.I will try to send you the tune tomorrow.
User avatar
By Bear27
#52255
Just got it back from them because it didnt trigger anything when i bought it..they did the vag cop mod at the same time when I sent it back for warrenty...maby I have the connector pins wrong to the coils.Do anybody know if ¹12v²ecu ground³signal⁴ground is right on a "115r" ngk R 05 01 s 004 00 coil?
By theonewithin
#52256
Wait. Are you actually testing you are getting a signal or just connecting a coil and expecting it to work and when it didn't assumed the ECu wasn't supplying a signal?

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?