Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By januzzz
#50412
Dear all,

i assembled a 0.3.7 board and tried the hardware test.
injection is ok but on the ignition only 1 channel is working.
inspected the board and looked in the schematics,and other then a resistor difference in BOM/schematics (160ohms in stead of 10 ohms) i couldn't find the problem in the board itself.
Started checking the clone mega, and found that the pinout is different from the schematics.

schematics pinout for ignition:
24,28,36 and 40.
actual pinout on mega:
38,40,50,52.

now is my question, do i need a earlier firmware?or can i adjust the pins in the settings?

thanks in advance.
Jan
User avatar
By PSIG
#50421
It appears you have the wrong board selected in TunerStudio. Default setting is v0.4-series (output on 38-40-50-52), and yours is v0.3-series.

Go to Settings > Engine Constants > Board Layout.

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?