- Wed May 19, 2021 7:58 am
#50412
Dear all,
i assembled a 0.3.7 board and tried the hardware test.
injection is ok but on the ignition only 1 channel is working.
inspected the board and looked in the schematics,and other then a resistor difference in BOM/schematics (160ohms in stead of 10 ohms) i couldn't find the problem in the board itself.
Started checking the clone mega, and found that the pinout is different from the schematics.
schematics pinout for ignition:
24,28,36 and 40.
actual pinout on mega:
38,40,50,52.
now is my question, do i need a earlier firmware?or can i adjust the pins in the settings?
thanks in advance.
Jan
i assembled a 0.3.7 board and tried the hardware test.
injection is ok but on the ignition only 1 channel is working.
inspected the board and looked in the schematics,and other then a resistor difference in BOM/schematics (160ohms in stead of 10 ohms) i couldn't find the problem in the board itself.
Started checking the clone mega, and found that the pinout is different from the schematics.
schematics pinout for ignition:
24,28,36 and 40.
actual pinout on mega:
38,40,50,52.
now is my question, do i need a earlier firmware?or can i adjust the pins in the settings?
thanks in advance.
Jan