- Tue Apr 27, 2021 6:28 pm
#49886
I tested the MAP at the pins into board, sensor responds to vacuum/pressure change via multimeter.
However, Tuner studio shows the signal erratic at zero with no change to Vacuum/pressure when applied.
All other sensors working good except the TPS, as it increases in percentage, it will influence the reading of the MAP gauge.
Could this be a short in my board somewhere? If so, any short cuts to check? Should I start removing capacitors, resistors in the two circuits, or is there an easy adjustment?
However, Tuner studio shows the signal erratic at zero with no change to Vacuum/pressure when applied.
All other sensors working good except the TPS, as it increases in percentage, it will influence the reading of the MAP gauge.
Could this be a short in my board somewhere? If so, any short cuts to check? Should I start removing capacitors, resistors in the two circuits, or is there an easy adjustment?
I welcome any help, I'm an old dog trying to learn new tricks.