Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By Marius222

My IAT readings are fine. But CLT stuck on 82c sometimes -17 if I change resistance manually.
0.4.4b (speeduino-202012release)
Car: Ford sierra Pinto engine
Please help! THX
User avatar
By jonbill
I think mine said 82 until I connected it and calibrated it.
I take it yours is connected, so maybe the wrong board is selected?
User avatar
By jonbill
yes, I think the arduino pin for it might vary with the speeduino board, so you have to select the right speeduino board in tunerstudio.
By Marius222
Its all winter project for me. If I see update I take speeduino from car take back home and update. I did not use any other version before. Today was the first start of the car but CLT readings fail. Yesterday I installed speeduino-202012, today started the car. IDK what was the readings before the update :(
User avatar
By jonbill
No reason to think there's a problem with that firmware, I'm sure others would have spotted if it didn't read the CLT sensor.
I would guess there is a physical connection problem - the sensor is not connected to the arduino pin.
PCB for BMW m52 engine

ok, thanks. i will keep looking for any solution[…]

92 eunos cold start

In the starttuo settings - cranking settings you h[…]

Hi i am from iran. Icant buy the pcb filea. Are yo[…]

I took a quick sqwiz at the code and ini, and cant[…]

Still can't find what you're looking for?