Engine protection in TS

Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
 Reply

Engine protection in TS

By Adam_86
-  Sat Jan 30, 2021 4:06 pm #47908
The engine protection On/Off and boost limit On/Off indicator is not reset to off after Boost cut protection. After a boost cut it stays on.
It needs a new line in the code in engineProtection.ino to reset the indicators to off at line 36

Image

Image
 Reply
 Return to “Bugs / Issues”
Ditching the CDI in Small Engines - Motorcycles, Gokarts etc

Let me give more context. I'm trying to replace t[…]

READ MORE
Crank signal Setup for single cylinder 250cc motorcycle engine. Suzuki GN250

Sorry, i just realized one thing: The 25 degrees […]

READ MORE
Do you have any other suggestions on how to achieve this?

Hi y'all, I want to add a new 3-D table for Inj[…]

READ MORE
Engine first start problem Peugeot 306 wheel decoder angle??

Yes as mentioned its 114 degrees, most older (rece[…]

READ MORE
VIEW MORE TOPICS

Still can't find what you're looking for?

Try the Wiki!