Engine protection in TS

Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
 Reply

Engine protection in TS

By Adam_86
-  Sat Jan 30, 2021 4:06 pm #47908
The engine protection On/Off and boost limit On/Off indicator is not reset to off after Boost cut protection. After a boost cut it stays on.
It needs a new line in the code in engineProtection.ino to reset the indicators to off at line 36

Image

Image
 Reply
 Return to “Bugs / Issues”
No Tach/No Lights on 0.4.3d using ardustim

Ok, I feel so stupid. I was running the Uno output[…]

READ MORE
1981 VW Rabbit here for research (Build)

Let's all have a laugh for second. There's trash[…]

READ MORE
Flex Fuel and Returnless Fuel Pump Control With Rail Pressure

It has been done more than a few times, there was […]

READ MORE
Opel Astra G project, original Ecu + speeduino (Parallel/piggyback)

Thanks yes, I would really appreciate all the help[…]

READ MORE
VIEW MORE TOPICS

Still can't find what you're looking for?

Try the Wiki!