Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
User avatar
By exvils
#47292
So i was playing with BT modules and HC05(zs040), HC06 and JDY31 sends after disconnecting "+DISC:SUCCESS" message which bricks serial/fw and ecu won't connect anymore unless restarted.
However this wasn't big problem with both hc05 and hc06 because anyone still have made connection, but with jdy31 you can't even connect as it sends "CONNECTING<<*mac address here*" and after that "CONNECTED" messages.
---------------
Is there a way to make a filter in .ini that would block/ignore "not a command" messages?
---------------
i added photos of output from terminal where i tried to connect twice to ecu via MSDroid app (qsqsqs is signature request) followed by disconnecting from BT
stuff in terminal is output from BT that would be wired to ECU (TX from BT to RX on arduino if i remember well), but i wired tx from bt to another mega to observe communication
Attachments
zx040 – copy.JPG
zx040 – copy.JPG (23.06 KiB) Viewed 2107 times
jdy31 – copy.JPG
jdy31 – copy.JPG (31.41 KiB) Viewed 2107 times

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?