Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By Slydit
#46612
ok so ive modded the 202008 firmware to change the pin assignments for a no2c to run sequential.(using vvt and boost for injectors 3+4)

ive literally unzipped the firmware from the github, opened the speeduino file and edited the init file, then compiled and uploaded to the arduino board.
but tuner studio says the modded firmware version is 202009b and of course theres no def file for this new firmware.

why is TS saying this modded firmware is 202009? is there somewhere i can change the firmware version description back to 202008 so it doesnt come up with this error box on every repower??

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?