Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By Tankki123
#45879
Hello ! Im running speeduino on my Bmw m50 turbo (stock vr sensors).
Running it on sequential fine till today, full throttle pull with 1st and 2nd gear till rev limiter, then engine turned off and didnt start.
Doesnt sync on cranking...
On semi sequential all works again so seems like it doesnt get signal from camshaft position sensor.
I check all the wires and they are OK, I also tried with another sensor and the problem still same.
What could cause this ?
I dont have a log from this pull, and there is no any changes in msq from other days while it was working.
Thanks guys !
By theonewithin
#45883
If you are sure sensor and wiring is good all the way to ECU, the input on the Arduino may have failed.

Replacement will be needed
By dazq
#45884
Try a composite tooth log to see if the MCU can see the cam input
By Tankki123
#45887
theonewithin wrote:If you are sure sensor and wiring is good all the way to ECU, the input on the Arduino may have failed.

Replacement will be needed
I replaced the Arduino with a new one, but problem is still the same :cry:
By theonewithin
#45892
Tankki123 wrote: Fri Oct 16, 2020 8:26 am
theonewithin wrote:If you are sure sensor and wiring is good all the way to ECU, the input on the Arduino may have failed.

Replacement will be needed
I replaced the Arduino with a new one, but problem is still the same :cry:
Then either your wiring is no good, the sensor is no good or the Speeduino board has a fault.

Easy to check each of those.
By Tankki123
#46349
Yep, i replaced the vr conditioner and everything works now.
I tought the same at beginning, thanks to all!

It looks like you have a fuel supply issue. readin[…]

Will this have an updated version about this featu[…]

Vr Conditioner Noise when cranking

I did the fix, but it's not work. I put my setti[…]

Perhaps some different points and pictures. Instr[…]

Still can't find what you're looking for?