Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By Knack
#45407
I was running 202005 and the fuel pump priming worked fine. Now that I have updated to 202008 it only primes the pump for about 0.5 second if at all. But the engine will still start and run just fine. i have tried changing the time to 3, 4 and 6 seconds, with no change.

Anybody else see this?
By theonewithin
#45411
Check through ALL settings.

A lot changed in the latest firmware.

You may need to start fresh and load Speeduino base tune first then load your tune over the top and check everything again.

you could set 'skip revolutions' to 3, then it wou[…]

Hi, I am trying to assign Signed values to the x-a[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?