Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By Ilotalo
#42983
I just upgrade my ecu to 202002 firmware.

I was cruising my car and in middle of it engine got lean. then i press clutch on and engine died. Under rolling i rise clutch and engine start. No problem after that. I didn't turn power off.

Here is log about it and issue starts in 855s
Attachments
(3.27 MiB) Downloaded 240 times
By Black Knight
#42987
Ilotalo wrote: Wed May 20, 2020 2:39 pm I just upgrade my ecu to 202002 firmware.

I was cruising my car and in middle of it engine got lean. then i press clutch on and engine died. Under rolling i rise clutch and engine start. No problem after that. I didn't turn power off.

Here is log about it and issue starts in 855s
Not sure here but did your ecu go off line at this point and reload?

If yes did your computer go into any power saving mode?
Screen protector, battery savings, or any thing like that.
This can interrupt the ECU 5v long enough to shut down and reboot.


I will look at the log later.


Black Knight
By Ilotalo
#42992
Black Knight wrote: Wed May 20, 2020 6:21 pm Not sure here but did your ecu go off line at this point and reload?

If yes did your computer go into any power saving mode?
Screen protector, battery savings, or any thing like that.
This can interrupt the ECU 5v long enough to shut down and reboot.
Look that log first.

No my computer didn't do anything. I'm using bluetooth so i can avoid that kind off 5v interrupts.

I change my processor card so i can see if that problem was in that.
By Black Knight
#42998
Ilotalo wrote: Wed May 20, 2020 8:24 pm
Black Knight wrote: Wed May 20, 2020 6:21 pm Not sure here but did your ecu go off line at this point and reload?

If yes did your computer go into any power saving mode?
Screen protector, battery savings, or any thing like that.
This can interrupt the ECU 5v long enough to shut down and reboot.
Look that log first.

No my computer didn't do anything. I'm using bluetooth so i can avoid that kind off 5v interrupts.

I change my processor card so i can see if that problem was in that.


Just spent a few hrs looking at my logs and solved many issues. I will look at yours when my head is ready for more. This may be over my pay grade but I can learn from trying.

Black Knight

Always going to be one, I have completed 3 convers[…]

Do i have to do something in arduino software ? i […]

STM32 development

Not yet, I have been too busy to look into it but […]

Hola a todos Actualizo!!! Me es grato comunicaros[…]

Still can't find what you're looking for?