Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For anything related to these forums itself including moderation, suggestions, artwork etc.
User avatar
By PSIG
#26456
That's a good setup for testing a trigger wheel and sensor distance. 8-) If you just want to check function, whether on the vehicle or on the bench, just apply power and connect an LED and resistor from the +V wire to the sensor signal pin. Most automotive Hall sensors are open-collector or open-drain, so it will light the LED when something ferrous (wheel tooth, wrench, etc) comes near.

David

Simple connection often by back-probing the connector terminals (no soldering) with an LED and resistor:
Hall Function Test LED.jpg
Hall Function Test LED.jpg (16.85 KiB) Viewed 4349 times

Check all the settings in TS. Make no assumptions.[…]

Wired as you told and I started the test mode. Has[…]

You seem new to the VW conversion community. My co[…]

Weird TPS+voltage problem

So I've spent some time googling and looking aroun[…]

Still can't find what you're looking for?