For any discussion not specifically related to your project
Topics
Title Statistics Last post
88 Replies 
251870 Views
by Waylon Queen
1 Replies 
217 Views
by dazq
Bias resistor value
by Eiska  - 
1 Replies 
632 Views
by JHolland
More programmable output rules?
by AlexE  - 
5 Replies 
814 Views
by PSIG
b18c1 trigger setup
by sinatrablue  - 
1 Replies 
608 Views
by jonbill
0 Replies 
587 Views
by Logicaluk
NO2C MEGA 2560 PINOUT IMAGE - Is this right ?
by usatracy  - 
4 Replies 
1197 Views
by usatracy
non linear analog signal datalogging
by Rocket  - 
6 Replies 
1320 Views
by Rocket
Is it best to inject on open or closed valves?
by E4ODnut  - 
7 Replies 
1740 Views
by PSIG
Info on Teensy (for use with UA4C)
by gcosens  - 
5 Replies 
2058 Views
by gcosens
How does Kohler do it ?
by usatracy  - 
6 Replies 
654 Views
by usatracy
Speeduino at high altitudes.
by tanximing  - 
5 Replies 
3583 Views
by usatracy
Individual cyl timing
by Old Grey  - 
29 Replies 
15512 Views
by JHolland
What's going on with my three pin Bosch ICV?
by Shalmaneser  - 
12 Replies 
2426 Views
by Shalmaneser
4.3d oil pressure/fuel level inputs
by HandCrank  - 
2 Replies 
1418 Views
by PSIG
storage on speeduino
by freak  - 
5 Replies 
1437 Views
by noisymime
ESP32 microprocessor?
by infinityedge  - 
14 Replies 
10848 Views
by usatracy
Ardu-stim help me please
by George kennett  - 
5 Replies 
1543 Views
by usatracy
Dynamo vs Alternator?
by worthidlj  - 
9 Replies 
1950 Views
by usatracy
double firing on ignition chnl 1 and 3
by emrefe  - 
7 Replies 
1194 Views
by emrefe
Password problem
by tojomojo  - 
1 Replies 
639 Views
by jonbill
0 Replies 
1125 Views
by Reg Noyce
Throttle wiring
by Rx8 project  - 
4 Replies 
785 Views
by Rx8 project
Making twostrokes great again 2023 edition
by JB21  - 
4 Replies 
960 Views
by dazq
Ignition latency/delay setting
by metcap  - 
60 Replies 
4588 Views
by JHolland
  • 1
  • 2
  • 3
  • 4
  • 5
  • 33

It looks like you have a fuel supply issue. readin[…]

Will this have an updated version about this featu[…]

Vr Conditioner Noise when cranking

I did the fix, but it's not work. I put my setti[…]

Perhaps some different points and pictures. Instr[…]

Still can't find what you're looking for?