Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
Topics
Title Statistics Last post
Reporting bugs
by noisymime  - 
29 Replies 
98306 Views
by RogerioTonin
Reading RPM off 4 tooth irregular cam
by Lex_GTX  - 
2 Replies 
1056 Views
by Lex_GTX
9 Replies 
2127 Views
by AlexE
INJECTORS DOESNT WORK,EVEN ON TEST MODE
by Canary90  - 
5 Replies 
736 Views
by Canary90
9 Replies 
787 Views
by Mini1300SPI_cryman
how to handle values beyond firmware limits
by Jaap Struyk  - 
4 Replies 
4019 Views
by 65ShelbyClone
202402 firmware and Realdash
by Juan Figueroa  - 
1 Replies 
1962 Views
by Plugger
C19 on Speeduino 0.4.3d TH board
by bugeye59  - 
2 Replies 
1269 Views
by bugeye59
Wierd problem with Daihatsu+1 Decoder and Nissan CAS
by Pezi  - 
6 Replies 
2838 Views
by Pezi
Simultaneous injector execution
by HSPRZEPA  - 
18 Replies 
4260 Views
by LPG2CV
speeduino.com/fw
by esasohl  - 
3 Replies 
988 Views
by dazq
8 Replies 
1404 Views
by youngfg
Battery Voltage Warning
by Vodkannelle  - 
4 Replies 
1143 Views
by dazq
No sync when uneven cranking
by joehawary  - 
10 Replies 
1863 Views
by PSIG
No spark signal
by Bear27  - 
18 Replies 
10141 Views
by Bear27
Tach output unstable
by AlexE  - 
2 Replies 
7304 Views
by PSIG
7 Replies 
2167 Views
by darreng
RPM output signal
by Ilotalo  - 
13 Replies 
12755 Views
by fenderer
U1 WAY too hot!
by sdiddy68  - 
3 Replies 
3708 Views
by JHolland
No fuel supply signal
by oreolai  - 
2 Replies 
988 Views
by oreolai
Connection prob Tunerstudio/speedloader
by Caribou  - 
1 Replies 
1060 Views
by jonbill
RPM spike causing engine shut off
by peroni93  - 
2 Replies 
1010 Views
by peroni93
12 Replies 
2615 Views
by Globule
0 Replies 
985 Views
by Jeppie
ECU rpm reading half actual rpm
by Bodie  - 
2 Replies 
4631 Views
by PSIG
  • 1
  • 2
  • 3
  • 4
  • 5
  • 12

Is the brightness control done by adjusting the su[…]

Dropbear V2 Availability

Thanks for the response - I think I'll wait for th[…]

Please post: ECM version and any module versions […]

Hello everyone, the Gerber files are now available[…]

Still can't find what you're looking for?