[marga]

Hello everyone. And thank you very much for the help that is provided in this forum. First of all, sorry for my English.

Ok, I'm using board 0.4.3c, with VR signal conditioner.
With the simulator on the table it works,
Speeduino reads rpm, but won't start. Engine stalls.
Wheel decoder angle error. 116th, no start. I used 244, 250,120,115... it always gives problems.
Can anybody help me.

Thank you so much .

[PSIG]

Hello everyone.

Hello!

Speeduino reads rpm, but won't start. Engine stalls.

Please post a ZIP file containing your tune file and a log of starting attempt using that tune.

Wheel decoder angle error. 116th, no start. I used 244, 250,120,115... it always gives problems.

Have you set your Trigger Angle using a timing light?

[turtana]

The Angel IS 114' tooth with IS 6'
I personally use 1815 or Max 9xxx series VR converter, they Work The best with 3 pin Black senror (25 cm lead)

The older codes did not Work Grate with The 60-2 i woul upgrade The codes.

[Chipboy]

Yes as mentioned its 114 degrees, most older (recently) peugeots use this,. 205. 306 and 405, Was helping a friend the other day using another ECU get to this point, he had not allowed for the offset of the VR sensor from the TDC marker and as soon as we put in 114 it started, and continues to run as he tunes it.