New wiki and manual has launched! Check it out at http://wiki.speeduino.com
For any discussion not specifically related to your project
By Jim_Coupe
#41668
Hi, Thinking of running 6cyl COP.. But speeduino outputs 12V not 5V.. Is there any thread around here for examples? dida search found nothing.. Also E-Gas is it support for that?
By theonewithin
#41681
Ignition outputs are 5/12v selectable. See the wiki for details.

No egas support.

Also Sequential over 4 cylinder is not well supported for either fuel or ignition.

It can be done but is not a simple task and you can have either ignition or injection not both.

There is basically no reason to go sequential in most cases anyway so best to explain what your setup is to be so someone can suggest if it would be of any benefit.
User avatar
By PSIG
#41703
Jim_Coupe wrote:
Tue Mar 24, 2020 11:25 am
… Also E-Gas is it support for that?
E-gas has multiple meanings. Do you mean ethanol/gasoline blends, or the proposed 'E-gas' natural-gas-based fuels? Ethanol blends (0-100%) and flex-fuel sensors are supported.

David
By runesm
#41717
theonewithin wrote:
Wed Mar 25, 2020 1:01 am


Also Sequential over 4 cylinder is not well supported for either fuel or ignition.
It's riiiight on the verge of being there though, with 6cyl full seq on the mega. :)
Ignition timing LED light

Jumper 1 is not set :( I will set it on 5v and rep[…]

Another Honda Build :P

Good day to every one As far as progress none so[…]

I think the main challenge here will be controllin[…]

R1 Thunderace trigger

Apologies for raising this old thread, but those a[…]

Still can't find what you're looking for?