New wiki and manual has launched! Check it out at http://wiki.speeduino.com
Anything not specifically related to the Speeduino hardware. Eg sensors, bluetooth, displays etc
By Dos_cat
#41663
Hi all, I'm in the midst of getting everything prepped for installing speeduino on my 92 b2200. I finally got the oem efi distributor, I know that it's a optical mitsubishi type with two trigger patterns on the trigger wheel. It looks sorta like the 4g63/na miata setup but I'm not sure, any help figuring it out would fantastic. I've attached a pic of the trigger wheel.
http://imgur.com/a/8Wnm0Dz
User avatar
By PSIG
#41697
As the crank and cam signals overlap, 4+1 will probably not work. I'm thinking that Dual Wheel set-up as a 2/1 (not 2+1) could be the approach, with crank signal at half-speed. Note in the image below, you have a choice of which edges to use for signals. For example, the cam (cycle) signal could use either the red or yellow edge, but the yellow edge is well-clear of any other signal points.

David

B2200_dist_wheel.jpg
B2200_dist_wheel.jpg (143.27 KiB) Viewed 148 times
4CK1CM_dist_setup.jpg
4CK1CM_dist_setup.jpg (106.11 KiB) Viewed 148 times
Ignition timing LED light

Hi Luke What do you have jumper 1 set to?

Another Honda Build :P

Good day to every one As far as progress none so[…]

I think the main challenge here will be controllin[…]

R1 Thunderace trigger

Apologies for raising this old thread, but those a[…]

Still can't find what you're looking for?