New wiki and manual has launched! Check it out at http://wiki.speeduino.com
Anything else whatsoever... Keep it clean though.
User avatar
By GregorSamsa
#41635
Greetings!
My name is Georgi Georgiev from Bulgaria, Eastern Europe. I have been following the speeduino project for quite some time.

I am in the process of building a forced inducted m42b18 engine, using the magnificent pnp board by pazi88. My plans are being delayed due to the current health situation. My employment as a software developer suffered, too. So it turned out that I have some free time.

Long story short, I am using Qt C++/Qml and have some experience working with embedded stuff. I do love open-source and would like to contribute to the community.

If you have any ideas for tools that might be of use, do not hesitate to contact me.
User avatar
By PSIG
#41642
Nice to finally see you, Georgi! 8-) Please join Slack and workrooms there, such as #development and #git.

David

I think the main challenge here will be controllin[…]

R1 Thunderace trigger

Apologies for raising this old thread, but those a[…]

This should now allow 6 and 8 cylinder semi-seque[…]

Pin 7 is the mega pin, not the pin on the 40 pin c[…]

Still can't find what you're looking for?