The original v04 design files are fritzing, some third party boards were completed with kicad ( as are the newer official boards) and Even a few in eagleThe-Gingineer wrote: ↑Fri Mar 20, 2020 9:15 pmThanks, I'd like to make some of the simpler adaptations earlier, particularly the connector. I also have wasted spark, so there's no reason to polulate additional drivers. I really just mostly need to know what program I can open the files in for modification. I cloned the GIT, but I'm a bit fuzzy on how to open it all in Easy EDA or KiCad
LPG2CV wrote: ↑Sat Mar 21, 2020 7:07 amYou don't have to remove components for it to work, just don't connect anything to them and it will be fine. So if you don't want ign channels 3 and 4, then don't connect to the pins.
It sounds like you want to have fun designing your own, but there is also NO2C
No overhang 2 channel. So the same footprint as the mega2560. That may help if you have restricted space.
Jumper 1 is not set :( I will set it on 5v and rep[…]
Good day to every one As far as progress none so[…]
I think the main challenge here will be controllin[…]
Apologies for raising this old thread, but those a[…]