Second firmware live stream happening this weekend: viewtopic.php?f=13&t=3992
Any questions you have before you begin buying, building and installing.
User avatar
By zoidberg
Hi there,
i just soldered my speeduino kit and it works like a charm except ignition channel 2
first i thought i fucked something up but debugging i found out that ignition channel 2 on the arduino never goes high.
which sucks a bit because i just need 2 channels for wasted spark but as the ignition channels cannot be reconfigured...
User avatar
By zoidberg
configured it for 0.4 i think i had it configured for no2c which resultet in it not working at all but now its 0.4
Should i create a new project and try it again?
User avatar
By zoidberg
no didn't help
was on speeduino 0.4 already. i even reflashed it with the last 2019 firmware but that didn't help either.
i suspect that that is an arduino problem not a speeduino one.
Sadly it seems impossible to remap the ignition outputs.
As only need 2.
User avatar
By zoidberg
speeduino 0.4.3.c
says tapr 1.0 and josh steward on the silkscreen

I just flashed a generic blink test programm and pin 38 and 40 are working.
with speeduino on the other hand and hardware testing through tuner studio 38 is not working.

Just be careful with the firing order.... as the […]

I fixed the timing problem, it has no jitter now. […]

New 202005 firmware

is it possible there's something particular in you[…]

Yes although a simple trigger for fuel only will s[…]

Still can't find what you're looking for?