New wiki and manual has launched! Check it out at http://wiki.speeduino.com
For discussion of Speeduino compatible boards designed / built by other members of the forum and for guidance around making such a board
By Hasse.69
#41731
Any progress on this one?
It's realy interesting.
By Dagaz_Psi
#41747
Yeah it works, have two cars running on it at the moment.
The two problems i have had is that the main relay wont get activaited the way I tought, so i hade to move it to the ac on pin and use a 2n2222 and a 7.5k ohm resistor to 12v.
The other is that I get power the backway from were I put the extra injector outputs. Because there are diffrent versions of the harnesses depening on model and years.
But the ecu connector is realy easy to depin and repin.
By Hasse.69
#41752
Would it be possible to buy PCB,s from you to SPEEDUINO my 944FTT?
Ignition timing LED light

Jumper 1 is not set :( I will set it on 5v and rep[…]

Another Honda Build :P

Good day to every one As far as progress none so[…]

I think the main challenge here will be controllin[…]

R1 Thunderace trigger

Apologies for raising this old thread, but those a[…]

Still can't find what you're looking for?