[runesm]

Hi guys,
some good news upon end of the year:
BlitzBox is now officially supported in speeduino firmware (pull request #1148).
You can compile the the official code by your own or wait until next official release/update from noisymime.
There will also show up soon a newer pcb release with optimized handling for environments with hall sensors (without MAX9926)
Best regards and happy holidays,
Chris

Beautiful. Very well done. Happy holidays to you too

[ME124]

Hello from beautiful Bavaria ,

after soldering the Bosch and MAX IC I programmed the Blitzbox and got my engine running.

But there are still some problems.
Maybe you guys can help me with them.

Is there any configuring of the Bosch IC needed?
I connected all the pins to the probe and Pin 4 to +12 V but I get no Lambda reading.

I connected Pin 14 to my MAP Sensor but there is no sensor reading.
+5 V and ground are connected and all my other sensors are working.

One additional thing:
Is it normal that the Blitzbox does some resets when plugging in the USB?
When I plug in the USB I hear the fuel pump relay clicking like crazy.
After a few seconds it stops and the ECU connects to tunerstudio.

Best regards
Mario

[Carsten]

Hey Mario,

which version did you purchase?
I want to order PCBs to Germany soon. Maybe you can share some experience?

Regards from the "Nordpfalz"

Carsten

[ME124]

Hey Mario,

which version did you purchase?
I want to order PCBs to Germany soon. Maybe you can share some experience?

Regards from the "Nordpfalz"

Carsten

I went with version 0.1.9 and ordered it at JLCPCB.
Worked like a charm.

Maybe my Chinese Bosch chips are the problem.
Is there a way to test them?

[Carsten]

Good to see that the latest version is fine.
I will order now as well...

Have you flashed the second micro-controller for for the wide-band circuit correctly?

What tools are available to check the function? Do you own an oscilloscope to dive deeper into the circuit?

[Carsten]

Hi all,

tried my order now at JCPCB. Unfortunately, I get an error message after uploading CSV files for the BOM and CPL files.
The system states that there are no components on TOP side of the PCB.

Any idea what is wrong?

Sincerely,

Carsten

[ME124]

Good to see that the latest version is fine.
I will order now as well...

Have you flashed the second micro-controller for for the wide-band circuit correctly?

What tools are available to check the function? Do you own an oscilloscope to dive deeper into the circuit?

I flashed both micro controllers via Arduino ISP and it seemed like it was working.
Maybe the Bosch chip is just not working.

Apart from the problems I wrote earlier the board works.
So if you don't mind these problems ordering is no problem.

Regarding your order:
I just did the ordering process again without any problems.
A few parts are not in stock at the moment, but there should be an alternative available ...

[Carsten]

Tried it again... Same issue

[Carsten]

Hello all,

finally, I made it... 10 PCBs ordered... Some components are missing but this should not be a big deal.

Price is surprisingly low...

CU Carsten

[Hich]

Hi Carsten,
do you need all 10 PCB or would you sell one to me?
BR Karsten