[bartekms43]

Here are dead times:
https://drive.google.com/file/d/0B2EFGt ... p=drivesdk

Remember to use open time only mode.

Also I don't recommend using closed loop idle control with pwm valve, untill the issues in that are fixed. Open loop mode with idle advance curve works great.

BIG thanks for xls for deka 630cc. I spend 5h to do in closedloop, never works. So u have right for that. Can u tell me how u setup idle advanced curve for m50nv(values to start) ?

[flat4power]

Have you same information for deka 875cc ?

[bartekms43]

Have you same information for deka 875cc ?

I can help. Use Pazi88 xls to convert to speeduino % values.

[pazi88]

Here is all that info in excel and ready to be put into speeduino: https://drive.google.com/file/d/0B2EFGt ... sp=sharing

[flat4power]

Thanks for your help guys

[Mariano3]

Hi. Does anyone have base tune for m42 engine? I have pcb 2.1. Thanks

[Amojancis]

Hi! I have some problems with voltage readings. In TS always shows 15.7v. When board is pluged to car it jumps to 16v. Voltage from alternator is 12.8-13.5v. Please point me where and what to check,my knowledges in electronics are not so strong to figure out by myself... Board is rev.2.1 for m4x with latest firmware.

[pazi88]

Check the battery voltage circuit. Probaply something there.

[Amojancis]

Hi! I have some problems with voltage readings. In TS always shows 15.7v. When board is pluged to car it jumps to 16v. Voltage from alternator is 12.8-13.5v. Please point me where and what to check,my knowledges in electronics are not so strong to figure out by myself... Board is rev.2.1 for m4x with latest firmware.

Board and all components was fine,solve my problem with new Arduino. Now voltage readings ar correct.

[exvils]

I just want to let anyone know who who wants to use sequential with VR cam sensor on v1.4 board (with m42 and m43 engines) that there is no pull up for camshaft input after VR conditioner output, so you have to add 10k resistor from +5V to tach1-d18/out2