New wiki and manual has launched! Check it out at http://wiki.speeduino.com
For discussion of Speeduino compatible boards designed / built by other members of the forum and for guidance around making such a board
By CROe34m50
#41724
I conected the assembled board to tuner studio and opend a new project loaded the 202002 firmware and it reconized it from there it opened the gauge cluster and powered up from there i assume i have to load a msq. tune
BUT i repeat i dont know how to get tunes from github there is no download for the msq. file
you can only see this tipe of letters.

<?xml version="1.0" encoding="ISO-8859-1"?>
<msq xmlns="http://www.msefi.com/:msq">
<bibliography author="TunerStudio MS Lite! 3.1.01 - EFI Analytics, Inc." tuneComment="" writeDate="Sun Feb 16 13:39:34 EET 2020"/>
<versionInfo fileFormat="5.0" firmwareInfo="Speeduino+2020.02" nPages="11" signature="speeduino 202002"/>
<page>
By CROe34m50
#41732
TNX i did it loaded the map i went trough some sensors calibrated tps and map is good at 99kpa.
I am going to get a registerd version of tunerstudio and will be making adapter for the chery hall sensor
what is the clearance from the tooth to the sensor ? 8-) 8-)
Attachments
20200326_143145.jpg
20200326_143145.jpg (3.99 MiB) Viewed 123 times
User avatar
By PSIG
#41737
CROe34m50 wrote:
Thu Mar 26, 2020 2:04 pm
what is the clearance from the tooth to the sensor ? 8-) 8-)
The sensor pictured appears to be the popular Cherry (ZF Electronics) GS100502. The datasheets (attached) say:

Operating Air Gap / Sensing Distance* 1.5 mm (0.06")
* With recommended target type; see drawing


David

(340.88 KiB) Downloaded 2 times
  • 1
  • 13
  • 14
  • 15
  • 16
  • 17
Ignition timing LED light

Jumper 1 is not set :( I will set it on 5v and rep[…]

Another Honda Build :P

Good day to every one As far as progress none so[…]

I think the main challenge here will be controllin[…]

R1 Thunderace trigger

Apologies for raising this old thread, but those a[…]

Still can't find what you're looking for?