[TurboPirate]

Thanks for the information, about my setup wish is the board 0.4, is there a wiring diagram of the 40 pin connector? Wish is injector, IAT, TPS etc.?

Read through the wiki all that information is in there

Found it.....sorry I did search but didn't find , I looked without searching and found it..I ordered today my first order, after I complete the second order will be bothering you all with more questions and photos. Thanks to you all for your time in helping me with this project. TP

[TurboPirate]

Hello gang, took the crank pulley out today and it has 58 teeth and 2 empty space, I uploaded photo just in case you see anything different........

[theonewithin]

That's what's known as a 60-2.

So it has 60 teeth but 2 are missing.

[TurboPirate]

That's what's known as a 60-2.

So it has 60 teeth but 2 are missing.

Thanks for clarifying that, I will remove the sensor tomorrow to see if its VR or HALL.......TP

[TurboPirate]

Sorry gang, today the weather here in Puerto Rico didn't agree with me, it was raining all day. I will remove sensor tomorrow.....again if weather lets me........TP

[TurboPirate]

Hello gang, I am super duper happy, today I got my first order........Hammond case, Mega2560, Steeper control thingy and the 0.4 board, more to come soon, I like to give thanks to TurboEdge for a very quick shipping, everything was well packed, I will definitely do my business with him..........

[turboedge]

TurboPirate:

Glad to hear your package traveled fast and safely. I hope the rest of the project follows the same path!

turboedge

[TurboPirate]

Sorry I haven't been around, but since 2018 my father in law died unexpected, then 2019 wasn't kind to me and 2020 started all wrong with earthquake since January 7, now Coronavirus has the island in Martial law, my project wish is also my passion is still on hold, can't wait for this to end..........TP

[TurboPirate]

I am back to finish my speeduino 0.4.3C thanks to WTMtronics I got all the items to populate the board, but now I no longer doing the same car. I think I have to start a new thread.........TP
P.S. This is the project you let me know if I have to start new
Mazda 323 1986, Factory Manual Transmission, 1.6L SOHC Fuel Injection with AFM, factory vacuum and mechanical advance distributor ignition.
I have spare 60-2 wheel from 2001 Daewoo Lanos, Throttle Body from GM 2.2L cavalier with stepper Idle
Throttle Body from Ford with 2 wire on/off Idle
Coil packs have from 2002 Neon and 1990 Ford Escort.....just to be sure let me know to start new thread thanks in advance TP

[PSIG]

I suggest a new thread with the make/model/engine in the title, to avoid confusion and to make searching easier. ;)

I had a nearly identical 323 but a '91. The daughter grabbed it just before I began hacking into it. A simple direct conversion first, then upgrade the wheel to higher resolution. Would have been easy and fun. :lol: