- Mon Apr 29, 2024 11:29 am
#68194
Hey all
I have an issue with idle stepper control on a V0.4 board driving a D5104 4 wire stepper motor. (Max 390 steps)
To begin with, Im using the Stepper Open Loop setting
On power up, the stepper runs towards home (closed) then moved back out to a set number of steps as expected.
After that, I have no further control over the valve.
Any ideas?
MSQ attached
I have an issue with idle stepper control on a V0.4 board driving a D5104 4 wire stepper motor. (Max 390 steps)
To begin with, Im using the Stepper Open Loop setting
On power up, the stepper runs towards home (closed) then moved back out to a set number of steps as expected.
After that, I have no further control over the valve.
Any ideas?
MSQ attached
Attachments
(86.26 KiB) Downloaded 8 times
- By ruckusman
- By panjaycee
- By Brandon
- By PSIG