[RobertGriggs]

I am a newbie to Speeduino and I have recently purchased a Speeduino v0.4.3c board and a Speeduino 4 channel ignition module from WTMtronics. I want to use Speeduino to control the ignition and fuel injection on my 1995 Mazda Miata 1.8L engine, which has a 36-1 trigger wheel and a VR sensor.

How can I wire and configure the Speeduino board and the ignition module to work with my engine? Are there any tutorials or guides that I can follow to make this process easier?

[jonbill]

Yes have a read through the wiki:
https://wiki.speeduino.com/en/home
And some on the youtube channel may help:
https://youtube.com/@Speeduino?si=OAm7Izs09bzOXM6x