- Mon Apr 22, 2019 6:00 pm
#34030
Welcome. Yes, though because it is highly configurable, it isn't hard but is also not super-simple. You can make your choices for when the dash light comes-on (on Speeduino signal out, on power output signal, on power switching detection at the relay or fan, etc), then we can guide you though wiring and settings.
One method I use is to enable a Local Auxiliary Input Channel input and pin, send/wire whichever signal source you like to it, then set a gauge or indicator to display the results, e.g., (random) Aux Input 06 pin D22 high or low. All selectable and configurable in TS. I have two of these pre-configured on my tuning dash, one for analog with a tiny needle gauge, and the other a digital on/off indicator that shows gray when off and bright green when on.
David
-= If it was easy, everyone would do it =-