For any pieces of hardware directly related to Speeduino (ie Boards, components etc)
#66839
I ordered the following board, unfortunately I had to buy 10 pieces but I only needed one for my experiments. I am now selling 9 pieces at cost price plus shipping costs to you.

Unlike many others, this board also has a voltage regulator so that it can be supplied with a voltage higher than 5V. But you can also omit this if you supply it directly with 5V.

The part works very well, you get an absolutely stable rectangle. Contrary to the circuit diagram, C4 and C5 can be made slightly smaller <300pF.
Attachments
Dual_VR_Board.png
Dual_VR_Board.png (62.61 KiB) Viewed 1296 times
Dual_VR_Board.jpg
Dual_VR_Board.jpg (287.08 KiB) Viewed 1296 times

If you want the simplest/easiest setup then you c[…]

Tach output and RPM sensor issues

Hi, I am in the process of converting the ignition[…]

BMW E23 M30B28

I'll figure out the tach eventually, but now there[…]

STM32 development

You won't be able to use a carrier board made for […]

Still can't find what you're looking for?