- Fri Sep 03, 2021 4:59 pm
#52898
Hi, just ordered a NO2C and will be fitting it to a Honda FJS600 that has a 12 tooth crank and 3 tooth cam wheel.
The cam wheel is attached to the exhaust cam (as per pic) but isn't evenly spaced, not sure of the degrees?
Q. is it easier to cut off 2 of the lobes on the cam wheel making it a 1 tooth, or is there a way to tell Tuner Studio/Speeduino the parameters?
TIA
Rick
The cam wheel is attached to the exhaust cam (as per pic) but isn't evenly spaced, not sure of the degrees?
Q. is it easier to cut off 2 of the lobes on the cam wheel making it a 1 tooth, or is there a way to tell Tuner Studio/Speeduino the parameters?
TIA
Rick
Attachments
honda fjs600 cam.jpg (54.64 KiB) Viewed 12404 times