- Sun Apr 04, 2021 1:43 am
#49459
Also if the cam input is configured for HALL it should measure 5V+
Dzeerve wrote: ↑Sat Apr 10, 2021 3:36 pm thanks for reply. bought a m54 cam sensor, plugged it in, set jp1 to 12v and still no luck. it reads incorrect values on tunerstudio, cam angle shows about - 18 degrees. should to be about 22 not - 18.But does it run seqventially? And how did you come into conclusion that it should show 22
Dzeerve wrote: ↑Sat Apr 10, 2021 4:24 pm ok, thanks. i will keep looking for any solution. it feels like engine is running only on few cylindersCheck that the inj/ign leds light up as they should when engine is running. Few times I have seen situation that the inj outputs especially work totally wrong in 6-cyl sequential setup. Eeprom clear to 255 and reload tune helps for that.
nice first of all, i read all that crap months a[…]
I rewired a few grounds and tested the TPS and rel[…]
Thanks, car runs great now !!! Going to drift even[…]
Still can't find what you're looking for?