- Wed Feb 24, 2021 10:23 am
#48606
Hi Klotzy_550
-You can improve some traces, eg direct connection for 5V close to ICSP connector (and remove 1 via)
-Remove all copper antennas (maybe you have to change the setup for copper generation) they are noise catcher from HF point of view, and nice antennas from RF point of view. (maybe we can catch the bluetooth! )
Also, at the end, you have to ground the ground , adding a lot of vias from top to bottom.
(Try to have a copper ground ring all over the board outline, if you can, with vias)
-You can improve some traces, eg direct connection for 5V close to ICSP connector (and remove 1 via)
-Remove all copper antennas (maybe you have to change the setup for copper generation) they are noise catcher from HF point of view, and nice antennas from RF point of view. (maybe we can catch the bluetooth! )
Also, at the end, you have to ground the ground , adding a lot of vias from top to bottom.
(Try to have a copper ground ring all over the board outline, if you can, with vias)
Attachments
k_500_2.JPG (274.09 KiB) Viewed 6054 times
k_500.JPG (236.36 KiB) Viewed 6054 times
GITHUB about my Custom Speeduino ECU: https://github.com/FRAMSPEEDUINO/CUSTOM_SPEEDUINO_ECU