[plazomat]

Hi,

Finally got car running using MS and basic distributor as a proof of successful wiring. Now ready to get it going on a custom speedy with crank trigger..

A while ago I remember seeing a wheel design/ calculator around here that was easy to design your own wheel and order one from them.

I can't seem to find it now that I am ready to purchase a wheel. Are they still around? Or alternatively does anyone know of an economical place to get?

I need about a 7.5 inch wheel, 36-1 - small block mopar crank application. Also any diy friendly hall sensor suggestions would be welcomed.

Thanks in advance for any help.
Plaz

[theonewithin]

I think it was/is linked to in the wiki?

[LAV1000]

If you want to make your own hall sensor;
https://www.allegromicro.com/en/product ... ics/ats627