Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any discussion not specifically related to your project
By plazomat
#46812
Hi,

Finally got car running using MS and basic distributor as a proof of successful wiring. Now ready to get it going on a custom speedy with crank trigger..

A while ago I remember seeing a wheel design/ calculator around here that was easy to design your own wheel and order one from them.

I can't seem to find it now that I am ready to purchase a wheel. Are they still around? Or alternatively does anyone know of an economical place to get?

I need about a 7.5 inch wheel, 36-1 - small block mopar crank application. Also any diy friendly hall sensor suggestions would be welcomed.

Thanks in advance for any help.
Plaz
Rover 36-1-1-1-1 wheel

Been out of the game for a while, but I'd be inter[…]

Chris, i told my ecu works on friends loom so i wa[…]

Twisting Wire/Twisted Pair

Connect the shield to earth / ground / negative at[…]

Nice! Does it make engine sounds? :D I always […]

Still can't find what you're looking for?