- Mon Nov 30, 2020 11:35 am
#46798
Well, two sandwiches, one glass of milk and a modified blink sketch later; the blink sketch sets pin 5 high (5V) and low (0V) as it should. So, D5 on the Arduino is working and it reaches R50 because that is where I measured.
In some way, the Speeduino is not sending the signal to D5. Where to look next, where are the pins assigned? Some .ini file somewhere? I have no clue, I used SpeedyLoader to get the firmware on.
Cheers,
Hugo
In some way, the Speeduino is not sending the signal to D5. Where to look next, where are the pins assigned? Some .ini file somewhere? I have no clue, I used SpeedyLoader to get the firmware on.
Cheers,
Hugo