[theonewithin]

READ THE WIKI.

[Maky1980]

OK, could you be a bit more specific about where to read within the wiki? Because reading I have already read it several times and I don't see what I'm looking for, that's why I ask. Thank you very much

[jonbill]

Its in the bit that describes the board.
e.g. https://wiki.speeduino.com/en/boards/V04

[Maky1980]

Its in the bit that describes the board.
e.g. https://wiki.speeduino.com/en/boards/V04

Hi.

first of all thanks for trying to help.

forgive my clumsiness but I still can't find pin 44 on speeduino, do I have to manually change it to one that is free?

Could it be that pin 44 of arduino is one of these: (29,30,31,32) in speeduino?

Again, thank you very much.

[jonbill]

oops, I thought your question was about 2 pin idle control pins.
dunno about idle up!

[theonewithin]

The pins are the Arduino pins.

Read the wiki.

Again.

3 or 4 times if you have to.

Look at the schematic for your particular Speeduino.

Check the firmware source code for default pins if you need to.

[Maky1980]

Hello again

Finally I managed to advance, the engine starts without accelerating although it costs a lot and the idle is very unstable, especially if I lower the rev and get close to 1000 rpm.

I am attaching a sample video.

https://youtu.be/DDQ-8Hl7ZBI

could these problems be related to the maps?

I appreciate any information.

[theonewithin]

That all seems perfectly normal for an untuned engine.

You have it running.

Time to learn how to tune it.

[Maky1980]

That all seems perfectly normal for an untuned engine.

You have it running.

Time to learn how to tune it.

thanks

[Maky1980]

Hello again

I can't get the car engine to work if I have speeduino connected to the pc, it doesn't matter if I start with the pc already connected or I start up first and then connect the pc. The engine does not work and tunerstudio restarts the project as if it were offline and then connects again.

Any idea what might happen?

Thanks a lot